3-6
Procedure
1.
Remove the access panel if you are connecting the USB device to an internal USB connector.
For information about the removal procedure, see "
2.
Connect the USB device to the USB connector, as shown in
Figure 3-7 Connecting a USB device to an internal USB connector
3.
Install the access panel. For information about the installation procedure, see "Installing the
access panel."
4.
Verify that the server can identify the USB device.
If the server fails to identify the USB device, download and install the USB device driver. If the
server still cannot identify the USB device, replace the USB device.
Connecting the power cord
Guidelines
WARNING!
To avoid damage to the equipment or even bodily injury, use the power cord that ships with the
server.
Before connecting the power cord, make sure the server and components are installed correctly.
Connecting the AC power cord for an AC or 240 V high-voltage DC power supply
1.
Insert the power cord plug into the power receptacle of a power supply at the rear panel, as
shown in
.
