H3C UniServer BX1010E, Руководство пользователя

Страница: 13 / 48

1
c. As shown by callout 3 in Figure 1 , click Login .
Figure 1 Logging in to the OM Web interface
3. Perform the following tasks to power on the switch module.
a. Click Interconnect Module Management .
b. Select the target switch module.
c. Click Virtual Power and then select Power On .
d. Click OK .
Powering on the switch module from the OM CLI
1. Open a remote access program, set the SSH login parameters, and log in to the OM CLI.
Table 4 SSH login parameters
Parameter Setting
Protocol SSH
Port number 22
OM management IP
•
Management IP address (default):
192.168.100.100
•
Subnet mask (default): 255.255.255.0
OM username and password
•
Username (default): admin
•
Password (default): Password@_
•
By default, SSH access to OM CLI is enabled.
•
Data in this table is used as an example.
2. Information as follows is displayed after you access the OM CLI.
******************************************************************************
* Copyright (c) 2004-2020 New H3C Technologies Co., Ltd. All rights reserved.*
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
******************************************************************************