113
NOTE:
•
The media dependent interface (MDI) standard is typically used on the Ethernet port of network
adapters. The media dependent interface crossover (MDI-X) standard is typically used on hubs
or LAN switches.
•
For a combo interface, you can use either the copper port or the fiber port. To switch between the
copper and fiber ports, use the
combo enable
{
copper
|
fiber
}
command in interface
view.
Table 42 Fiber Ethernet port specifications
Item Specification
Connector type
LC
Transceiver module type
SFP
Interface standards
802.3, 802.3u, and 802.3ab
Operating mode
1000 Mbps, full duplex
10 Gbps Ethernet port
The MCP-X2 provides two 10 Gbps Ethernet ports. 10 Gbps SFP+ ports do not support 1000 Mbps
transceiver modules.
Table 43 10 Gbps Ethernet port specifications
Item Specification
Protocol 802.3ae
Connector type
LC
Transceiver module type
SFP+
Physical layer
10GBASE-R/W
Transmission rate
•
LAN PHY
—10.3125 Gbps
•
WAN PHY
—9.95328 Gbps
10GBASE-R-SFP+ port
Item Specification
Connector type
LC
Transceiver module type
SFP+
Interface standards
802.3ae
Operating mode
10 Gbps, full duplex
RESET button
CAUTION:
•
If you perform no save operation before resetting the router, the current system configuration will
be lost.
•
Never press the RESET button when the RUN LED is flashing fast or when the router is
accessing the CF card or a USB storage device. Otherwise, the file system of the router might be
damaged.
To reset the current MPU, press the RESET button.
