22
4.
(Optional.) If the FIP module has a protective cover at the connector end, remove the cover
and keep it secure.
Figure8-4 Removing the protective cover
5.
Press the red latch to disengage the ejector lever from the FIP module.
6.
Holding the ejector lever by one hand and supporting the FIP module by the other, push the
FIP module slowly into the slot along the guide rails.
7.
Close the ejector lever until the FIP module is securely seated in the slot.
Figure8-5 Installing a FIP module
Installing SATA drives
CAUTION:
•
The SATA drives are hot swappable. You can install a SATA drive, or remove a SATA drive in
RAID configuration as indicated by the LED without power off the device. To remove a SATA
drive not in RAD configuration, you must first power off the device.
•
For system identification, use SATA drives recommended by H3C.
To install a SATA drive:
1.
Wear an ESD wrist strap and make sure the strap makes good skin contact and is reliably
grounded.
