18
Installing interface switch modules or AI security engine
modules
CAUTION:
•
The interface switch modules are hot swappable.
•
The NSQM5AIASKA1 and NSQM5AIASKB1 AI security engine modules are hot swappable.
•
If you are not to install an interface switch module in an interface switch module slot, keep the
filler panel in the slot.
The procedure is the same for installing an AI security engine module and interface switch module.
The following installs an interface switch module.
To install an interface switch module:
1.
Wear an ESD wrist strap and make sure the wrist strap is reliably grounded.
2.
Remove the filler panel from the target interface switch module slot (service module slot). Keep
the removed filler panel secure for future use.
3.
Pivot down and fully open the ejector levers of the module. Gently push the module into the slot
along the guide rails.
4.
Continue to push the module by its front panel until you cannot push it any further. Then close
the ejector levers.
5.
Use a Phillips screwdriver to fasten the captive screws on the module.
6.
Pivot up the ejector levers on the module.
Figure 20 Installing the interface switch module (M9000-AI-E16)
