Installation Manual
H3C S9500 Series Routing Switches
Chapter 3 Installing the Switch
3-17
3.8.1 Installation Procedure
z
Wear the ESD-preventive wrist strap, making sure that it is properly
grounded.
z
Remove blank filler panels in the power supply area if applicable.
3.8.2 Installing the PoE Power Entry Module
The PoE power entry module is hot-swappable.
Follow the steps below to install the PoE power entry module:
1) Unpack the PoE power entry module, which is shown in
Figure 3-17
.
Figure 3-17
PoE power entry module
2) Keep the PoE power entry module in the correct letter direction. (Do
not turn it upside down. Otherwise, you will not be able to fully insert it
into the chassis due to mis-plug prevention design of the module, nor
can you fasten the chassis fixing screw.) Hold the bottom with one
hand and the front panel with the other, and then slide it smoothly
along the guide rails into the slot, until it snaps into the chassis. Make
sure the plug of the PoE power entry module is fully connected with the
socket inside the chassis. See
Figure 3-18
.