2-20
Figure2-32 Installing a power supply (LSVM1AC650)
Removing a power supply
CAUTION:
When an S6826-48Y8C or S9826-32C switch has two power supplies in 1+1 redundancy mode,
removing one power supply does not affect the operation of the switch. When the switch has only
one power supply installed, removing the power supply powers off the switch.
The LSVM1AC650 and LSVM1DC650 removal procedure is the same on the S6826 switch series
and S9826 switch series. The figures in this section use the S9826-32C switch as an example.
To remove a power supply:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Squeeze the tabs on the power cord connector with your thumb and forefinger, and pull the
connector out to remove the power cord, as shown in
3.
Hold the handle on the power supply with one hand, pivot the latch on the power supply to the
right with your thumb, and pull the power supply part way out of the slot, as shown in
4.
Supporting the power supply bottom with one hand, slowly pull the power supply out with the
other hand.
5.
Put the removed power supply in an antistatic bag for future use.
6.
If you are not to install a new power supply, install a filler panel in the slot to ensure good
ventilation in the switch.
