4
A default S-channel is created on an interface after EVB is enabled on the interface. Both SCID and SVID
are 1. After an S-channel is created, an S-channel interface or S-channel aggregate interface is created
and operates in access mode.
Do not enable both EVB and VLAN mapping, both EVB and TRILL, or both EVB and QinQ on the same
interface.
Do not create a service instance for an interface enabled with EVB, and vice versa.
Do not assign interfaces enabled with EVB and not configured with the
trill evb-support
command to the
same VLAN as interfaces enabled with TRILL. For more information about TRILL, see
TRILL Configuration
Guide
. For more information about the
trill evb-support
command, see
TRILL Command Reference
.
To enable EVB:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface
interface-type
interface-number
N/A
3.
Enable EVB.
evb enable
By default, EVB is disabled on an
interface.
Configuring LLDP
EVB uses LLDP to transmit CDCP TLVs, and CDCP TLVs are carried by the LLDP packet that is addressed
using the Nearest non-TPMR Bridge address, so you must configure LLDP.
For detailed information about the
lldp global enable
,
lldp enable
and
lldp agent nearest-nontpmr
admin-status
commands, see
Layer 2—LAN Switching Command Reference
.
To configure LLDP:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable LLDP globally.
lldp global enable
By default, LLDP is disabled
globally.
3.
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface
interface-type
interface-number
N/A
4.
Enable LLDP on the interface
lldp enable
By default, LLDP is enabled on an
interface.
5.
Configure the Nearest
non-TPMR Bridge agent for
LLDP to operate in TxRx mode.
lldp agent nearest-nontpmr
admin-status
txrx
The default mode is
disable
.
