94
Examples
# Set the maximum number of traps that can be stored in the trap sending queue to 200.
<Sysname> system-view
[Sysname] snmp-agent trap queue-size 200
snmp-agent trap source
Syntax
snmp-agent trap source
interface-type
interface-number
undo snmp-agent trap source
View
System view
Default level
3: Manage level
Parameters
interface-type interface-number
: Specifies the interface type and interface number.
Description
Use the
snmp-agent trap source
command to specify the source IP address contained in the traps.
Use the
undo snmp-agent trap source
command to restore the default.
By default, SNMP chooses the IP address of an interface to be the source IP address of the traps.
Upon the execution of this command, the system uses the primary IP address of the specified interface as
the source IP address of the traps, and the NMS uses this IP address to uniquely identify the agent. Even
if the agent sends out traps through different interfaces, the NMS uses this IP address to filter all traps sent
from the agent.
Before you can configure the IP address of a particular interface as the source IP address of the trap,
make sure that the interface already exists and that it has a legal IP address. Otherwise, if the configured
interface does not exist, the configuration fails. If the specified IP address is illegal, the configuration
becomes invalid. When a legal IP address is configured for the interface, the configuration automatically
becomes valid.
Related commands:
snmp-agent target-host
and
snmp-agent trap enable
.
Examples
# Configure the IP address for the port Vlan-interface1 as the source address for traps.
<Sysname> system-view
[Sysname] snmp-agent trap source Vlan-interface1
snmp-agent usm-user { v1 | v2c }
Syntax
snmp-agent usm-user
{
v1
|
v2c
}
user-name
group-name
[
acl
acl-number
]
undo snmp-agent usm-user
{
v1
|
v2c
}
user-name
group-name
View
System view