10
Figure 11
Mounting the switch to the rack (front mounting brackets at the power side)
5.
Connect the one-hole lug grounding cable to the rear grounding point (see "
Connecting the rear
grounding point to a grounding strip
").
Rack-mounting by using front and rear mounting brackets
(S5500-34C-PWR-HI and S5500-58C-PWR-HI)
This mounting method is applicable to only the S5500-34C-PWR-HI and S5500-58C-PWR-HI switches.
You can install the front mounting brackets at the port-side or power-side mounting position as needed.
The following takes port-side mounting as an example. The power-side mounting is similar.
This task requires two people.
To install the switch in a 19-inch rack by using the front and rear mounting brackets:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is correctly grounded.
2.
Attach the front mounting brackets and load-bearing screws to the chassis:
a.
Unpack the front mounting brackets and the M4 screws for attaching the brackets to the switch
chassis.
b.
Align the round holes in the wide flange of one front mounting bracket with the screw holes in
the port-side mounting position on one side of the chassis (see
Figure 12
).
c.
Use M4 screws (supplied with the switch) to attach the mounting bracket to the chassis.
d.
Repeat the proceeding two steps to attach the other mounting bracket to the chassis.
e.
Unpack the load-bearing screws.
f.
Install the load-bearing screws in one of the load-bearing screw mounting positions (see
Figure
12
) as needed.