H3C MSR3610-X1, Руководство по установке

Страница: 22 / 44

15
Figure 14 Grounding the device with a grounding strip
Grounding the device by burying a grounding conductor in
the earth ground
If the installation site does not have any grounding strips, but earth ground is available, hammer a 0.5
m (1.64 ft) or longer angle iron or steel tube into the earth ground to serve as a grounding conductor.
The steel tube must be zinc-coated. Weld the yellow-green grounding cable to the angel iron or steel
tube and treat the joint for corrosion protection.
Installing interface modules
Installing a SIC
CAUTION:
SICs are not hot swappable. Make sure the device is powered off before installing a SIC.
To install a SIC:
1.
Use a Phillips screwdriver to remove the fastening screws on the filler panel and remove the
filler panel. See
Figure 15 .
2.
Push the SIC slowly into the slot along the guide rails until it makes close contact with the
backplane of the device. See
Figure 16 .
3.
Fasten the captive screws on the SIC.