H3C MSR 20-20, Справочник по командам

Страница: 2231 / 2742

2231
vrrp un-check ttl
Syntax
vrrp un-check ttl
undo vrrp un-check ttl
View Interface view
Parameter None
Description Use the
vrrp un-check ttl
command to disable TTL check on VRRP packets.
Use the
undo vrrp un-check ttl
command to enable TTL check on VRRP
packets.
By default, TTL check on VRRP packets is enabled.
Example # Disable TTL check on VRRP packets.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] vrrp un-check ttl
vrrp vrid preempt-mode
Syntax
vrrp vrid virtual-router-id preempt-mode [ timer delay delay-value ]
undo vrrp vrid virtual-router-id preempt-mode [ timer delay ]
View Interface view
Parameter virtual-router-id : Virtual router ID or VRRP standby group number, in the range 1
to 255.
timer delay delay-value : Sets preemption delay. The delay-value argument ranges
from 0 to 255 and defaults to 0, in seconds.
Description Use the
vrrp vrid preempt-mode
command to enable preemption on the
router and configure its preemption delay in the specified standby group.
Use the
undo vrrp vrid preempt-mode
command to disable preemption on
the router in the specified standby group.
Use the
undo vrrp vrid preempt-mode timer delay
command to restore the
default preemption delay, that is, zero seconds.
The default mode is immediate preemption without delay.
On an instable network, the standby group member in the backup state may not
normally receive the packets from the master member due to network congestion,