H3C LSPM6G4T6, Руководство пользователя

Страница: 7 / 9

7
• Phillips screwdriver.
•
Flat blade screwdriver.
•
ESD wrist strap.
The installation tools are not provided with H3C devices. Prepare them
yourself.
Installing the card
1. Use the Phillips screwdriver to remove the screw on the filler panel in
the target slot, as shown by callout 1 in
Figure 2 .
Keep the removed screw secure for future use.
2. Insert the flat blade screwdriver through the handle on the filler
panel to pull out the filler panel, as shown by callout 2 in
Figure 2 .
Keep the removed filler panel secure for future use.
3. Unpack the card.
4. Insert the card slowly into the slot along the guide rails, as shown by
callout 1 in
Figure 3 .
5. Rotate inward the ejector lever as shown by callout 2 in Figure 3
until the card is in close contact with the switch.
6. Use the Phillips screwdriver to tighten the captive screw on the card,
as shown by callout 3 in
Figure 3 .
Figure 2 Removing the filler panel