H3C H3C SecPath F1800-A, Руководство по установке

Страница: 12 / 13

Installation Manual
H3C SecPath F1800-A Firewall
Chapter 3 Installation
3-11
At one end of the cable is an RJ-45 connector that can be plugged into the AUX
interface of the SecPath; at the other end are DB-9 (male) connector and DB-25 (male)
connector.
You can plug either of them into the serial port of Modem as needed.
Figure 3-10 shows the AUX cable.
Figure 3-10 AUX cable
For the pinouts of AUX cable, refer to “Appendix A”.
III. Connecting the AUX Cable
Follow steps below to connect the AUX cable.
Step 1: Insert the RJ-45 connector of the AUX cable into the AUX interface of the
SecPath.
Step 2: Insert the DB-25 or DB-9 connector of the AUX cable into the serial port of the
analog Modem.
The AUX interface is usually used for remote configuration through dial-up. In this
case, you need to connect the local Modem to the remote Modem through PSTN and
then to the remote equipment.
For the typical networking diagram and configuration procedure, refer to H3C
SecPath F1800-A Firewall Operation Manual .