H-P Products TURBINE POWERHEAD and HAND HELD TURBINE..., Инструкция по эксплуатации

Страница: 5 / 10

INSTRUCTIONS FOR HAND HELD TURBINE POWERHEAD
(A) ATTACHING THE HAND HELD TURBINE
POWERHEAD
To attach your metal wand and/or curved hose handle simply
twist into hand brush neck until it fits snugly. (See Fig. 1). To
detach wand or curved hose handle, simply hold neck of Hand
Held Powerhead and pull apart with a twisting motion.
(B) OPERATING PROCEDURES
Your hand held Turbine Powerhead has no on/off switch.
Whenever it is attached to an operating vacuum system, it will
be running. There is only one adjustment for the Brush. A suc-
tion control valve is located on the top left side. Slide the con-
trol valve open to reduce suction for cleaning draperies. (See
Fig. 2)
(C) CLEANING BRUSH
Turn off vacuum system and disconnect Powerhead Brush.
Threads, string, carpet fiber, fuzz, etc. can wrap around the cleaning brush. These should be removed by
unwinding them by hand or carefully cutting with scissors. (Note: Brown base plate should be removed to clean
properly). Keeping the cleaning brush clean will maintain efficiency of the Powerhead Brush.
(D) CLEANING INTAKE NOZZLE
If turbine or intake nozzle become obstructed:
1. Turn off vacuum system and disconnect Powerhead.
2. Remove brown base plate by first sliding the base plate latch toward the back of the brush. Next, pull the
rear of the plate away from the housing and slide forward to disengage front locking tabs. (See Fig. 3)
3. Remove debris from intake port and/or turbine.
4. Reassemble by inserting the tabs on the front of the base plate into the slots in the base housing, then
secure the back of the brown base plate with the latch.
Page 5