H-P Products EG1400, Руководство пользователя

Страница: 9 / 12

Maintenance and Care
To Replace Belt:
1. Install new belt (Part # 9439-01) over motor drive
then over belt path. (Fig. L)
2. Place agitator assembly back into EG1400.
(Fig. M)
3. Reinstall agitator cover by lining up the front
tabs and slots and rotating downward until
the latches snap into place. (Fig. N)
4. Line up front of cover and base. Rest
cover on front edge of base as shown. (Fig. O)
5. Rotate cover back. Press cover firmly until side
and rear tabs snap into place. (Fig. P)
6. Turn EG1400 upside down and replace 2 cover
screws.
Fig. L
Fig. M
Fig. N
Fig. O
Fig. P
Light Bulb Changing
1. Remove EG1400 cover as
shown in Belt Changing &
Agitator Cleaning.
2. Push in and turn bulb coun-
terclockwise, then pull out to
remove. (Fig. Q)
3. Push in and
turn bulb
clockwise to
replace.
Bulb must
not be higher
than 15 Watts (130 Volts).
(Fig. R)
4. Reinstall EG1400 Cover as
shown in Belt Changing &
Agitator Cleaning.
Fig. Q
Fig. R