above points may affect the safety of the appliance.
Should you decide not to use the appliance again, remove the plug from the socket and cut the
supply cable to render the appliance completely inaperative.
Installation must be carried out according to the manufacture’s instructions.
The supply cable must not be replaced by the user, as this requires the use of special tools, if the
supply cable is damaged, contact an authorized Service Centre.
Do not fill the appliance under a running tap.
Do not allow the supply cable to come into contact with the ironing plate.
If the safety cut-out intervenes, the iron will no longer function. To restore normal operation. Contac
a qualified electrician.
Never direct the steam jet in the direction of persons, as this may be extremely dangerous.
Do not use the iron on very wet fabrics.
Do not place the iron on the stand when the plate is hot.
Do not overfill the boiler and do not add stain-removers of simllar products to water.
Remove the plug from the mains socket when the appliance is not in use. Do not leave the
appliance switched on unnecessarily.
Never unscrew the safety valve when the appliance is connected to the power supply network.
Use a funnel to fill the boiler without causing the water to overflow.
The boiler must be placed on a flat surface that is particularly resistant to high temperatures.
INSTRUCTIONS FOR USE
Check the manu
facturer’s label on the garment, and interpret the symbol on label as follows:
Steam ironing allowed
For dry ironing, set temperature adjustment knob
（
4
）
on …
Steam ironing allowed
For dry ironing, set temperature adjustment knob (4) on …
Dry ironing
Check the fabric’s resistance to steam ironing or dry iron with
temperature adjustment knob (4) set on…
Do not iron
Steam ironing or treatment not allowed
STEAM IRONING
The appliance uses ordinary tap water.
If the water is very hard (hardness higher than27 degrees French).we suggest using distilled or
demineralized water.
When using the iron for the first time, iron a plain cloth first.
Before using the appliance, taken down the water tank (14) and fill it, not exceeding MAX
waterline.
When you want to take back the water tank(14),firstly put the water tank base and then push the
water tank softly, after hear “click”, it means the water tank in the place.
Connecting the appliance and power cord.
Press the switch button (7), power indicator light (6) and steam available indicator light (8) bright,
it means the boiler and iron start running.
Feed-water from electromagnetism water pump coming down the boiler when the boiler (13)
heating enough.
Choosing the temperature by temperature knob (4), the steam device indicate ironing area
which can be chose (Fig.3).
Around 2 minutes, heating indicator (2) will die out, it means the appliance can be using the
steam.
