GYS GYSPOT ARCPULL 200, Руководство пользователя, Страница: 22 / 88

22
GYSPOT ARCPULL 200
EN
Information panel
OVERHEATING DEFECT OVERVOLTAGE DEFECT
COM. DEFECT
Info
Soft gene V0.0
Hard gene V0.0
Soft gun V0.0
Hard gun V0.0
PRESSED KEY
zone de
message
Product reset
:3 sec
to reset
Configuration
> Pregas > 100ms
Postgas 500ms
Language EN
Product reset
Info
Synergic Settings
> Material > Fe
Gas ON
Electrode Ring
THK. elec. 1.5 mm
Main Menu
> Settings
Manual Mode
Configuration
t
ms
I
A
100 200
message
area
Manual Settings
Start-up > Q = 0
OVERHEATING DEFECT
MOTOR DEFECT
Ring 1.5mm
Fe Gas
+1 2.0
message
area
The information panel provides information on software versions and hardware of the
generator and gun (if it is connected).
CHANGE THE GUN EARTH RODS
Removal of the rods
• Loosen the earth rods locking wheel
• Unscrew the two front screws in order to slightly release the case towards the front
of the gun.
• Slightly unscrew the two screws used to hold the rods.
• Pull the rods up to remove them
Repositioning of the rods
• Insert the rods in their holes
• Adjust the length of the rods to obtain 12cm between the base and the tip.
• Tighten up the two screws holding the rods
• Reposition the case
• Screw the front screws back on
Note : When doing this, it is recommended to remove the electrode holder by loosening
the locking nut.
Front screw : Rod tightening screws :
Earth rod holes :
12 cm
CHANGE OF AN ELECTRODE HOLDER
Removal of an electrode holder
• Slightly unscrew the locking nut to show the electrode holder on the gun.
Repositioning of an electrode holder
• Position the electrode holder in the cannon of the gun.
• Screw the locking nut back on and check that the electrode holder does not move.
The locking nut must be tightened by hand. Do not use a clamp.
SETTING OF A DOWEL PIN HOLDER
Adjusting a dowel pin holder(049000 - 048157 - 048164)
• Unscrew the bolt and nut of the dowel pin holder.
• Insert the dowel pin in the nut holder.
• Aim at the screw of the nut holder to obtain 3mm between its extremity and the thread of the dowel pin.
• Block the nut.
Contre-écrou
Vis
3 mm