ERGO LIFT 650
6
Hydraulic fluid is dangerous if splashed in the eyes or if it comes into contact with blood. In
this case, contact your doctor immediately. Never reach over your hand to check for a hydraulic
leak: risk of cut and contamination in the bloodstream that could lead to death.
INDIVIDUAL PROTECTION
The operator must be equipped in accordance with the occupational risk prevention standards applicable in
his/her country and must adopt all necessary measures to maintain safety at his/her workstation. During
manoeuvres, the operator must ensure his own safety and that of the people and objects around him. The
operator must take into consideration all the recommendations quoted in this manual.
START UP
Make sure you have the necessary protection: safety shoes and gloves.
Step 1:
Place the ERGO LIFT on the floor and position the hydraulic unit 3 metres from the lift, making sure
that the beam is not twisted and bent.
Step 2:
Connect the hydraulic unit to an electrical outlet and set the button to "ON".
Step 3:
Place the 4 runners on the load-bearing elements.
It is possible to adjust the runners in height (1) and all along the arm (2).
Each skate is equipped with a solidly attached mechanical stop - never use a skate
without a stop.
Step 4:
It is possible to move the supporting elements (= arms) of the lift at an angle. To do this, lift the end
of the arm in order to release the movement, position it as desired and release it. After each repositioning,
check that the arm is securely in place and locked into a safety catch by making a left-to-right movement.
Never perform this operation with your foot. Always make this adjustment with your hand to carry out the
necessary checks of the correct positioning of each load-bearing element.
Hoist
Hydraulic power
Supporting element
Rubber pad
3m min
(1)
(2)
Remote control
Manoeuvring
drawbar
Electrical
outlet
