GYS ENERGY STATION FP, Руководство пользователя

Страница: 17 / 60

EN
17
Operating manual
ENERGY STATION FP
Translation of the original
instructions
Being a 12 V charger, the ENERGY STATION FP alternately charges each battery individually for 30
minutes. Any manipulation of the batteries during the charging process is strongly discouraged (re-
placing batteries or readjusting the polarities if they have been inverted, etc.).
If carrying out an operation on one of the two batteries is absolutely necessary, disconnect the product
from the mains supply, carry out the operation and then reconnect it.
Lead load curve
U
I
1 2 3 4 5 6
Analysis Recovery Test Desulphation Charging
Charge
holding
CHARGE
OK
Indica
tor
Max 12h <1s Max 8h <1s Max 24h No limit
Stage
1
: Analysis
Battery status analysis (charge level, reverse polarity or bad
battery connected, etc.).
Stage
4
: Desulphation
(15.8 V)
Battery desulphation algorithm.
Stage
2
: Recovery (10 A)
An algorithm for recovering damaged elements following a
deep discharge.
Stage
5
: Charging (30 A)
Rapid charging at the maximum current level to quickly reach
100% charged.
Stage
3
: Test
Sulphated battery test
Stage
6
: Charge holding (13.6 V)
Maintaining the batteries at full charge.
Charging an external 12 V battery
It is possible to recharge an external battery. However, in order to charge it faster, it is recommended that the internal
batteries are fully charged beforehand.
Charging an external battery
12V
BATTERY 2
Connect the cables to the ENERGY STATION FP’s 12 V outlet (red cable to the 12 V outlet,
black cable to the battery’s negative [-] terminal).
Connect the external battery using the clamps, making sure that the polarity is correct. .
ON
Set the switch to the ‘ON’ position.
Connect the charger to the 230 V (50 - 60 Hz) mains system.
Set the switch to the ‘ON’ position.
Charging will start automatically.
During the charging process, the device will indicate the batteries’ state of
progress.