18
User manual
GYSPRESS PREMIUM 10T PUSH-PULL
Translation of the original
instructions
MOUNTING THE FITTINGS
Screw the end-cap kit required for the riveting procedure into the arm support. Before each assembly, check that the die and rivet holder are correctly
paired (see page 4) and tightened securely.
As soon as the die and the punch support are in place, finish tightening with the delivered spanner. Check that the connection tips
are in place after each riveting process. Any loosening is dangerous and may cause damage to the riveter.
AIR PRESSURE CONNECTION
Maximum air pressure:
Make sure that the air pressure does not exceed 8 bar.
Clean compressed air:
Ensure that only clean, dry compressed air is used to feed the riveter. Moisture and dirt can lead to performance issues and/or
damage to the unit.
SPEED AND PRESSURE CONTROL
The user can manually adjust the speed of the ram and the rivet setting force, according to the type of material to be joined, in order to avoid any
deformation of the workpiece.. To set the pressure according to the dies and materials, see table at the end of the manual.
Speed
Pressure