GVM-VAC GVM6600-CM, Руководство пользователя

Страница: 35 / 131

35
GVM-VAC
www.gvm-vac.com
Operating Section
3.3 Dumping the Body, continued
figure 3.3d
figure 3.3e
figure 3.3g
figure 3.3f
6. Locate the Tailgate Latch Indicator Lights (fig. 3.3a). If
the Red light is lit then go to step 8.
7. Locate the tailgate latch control switch (fig. 3.3e) and
press the top of the switch open the tailgate latch, the
Red indicator light should come on.
8. Press the top of the Hoist Dump switch, (fig. 3.3e) to
start raising the body.
9. Raise the body only as high as it is needed to dump the
load.
10. Raise the body prop(s) (fig. 3.3f) to a free standing posi -
tion. Lower the body slowly until the long beam bracket
contacts the prop arm saddle (fig. 3.3g). DO NOT
POWER HOIST DOWN.
Lowering the body:
1. Before lowering the body, walk completely around
the unit and thoroughly inspect the area between the
body and the unit’s frame. Look for any object, person
or animal that could potentially get between the dump
body and the frame. DO NOT go under the body while
inspecting.
2. Once the load has been dumped, start the engine as
described in section 3.1. DO NOT race the engine.
3. Slowly raise the body just enough to clear the body prop
saddle, lower the body prop to the storage position (fig
3.3c) and slowly lower the body.
4. The dump body may stop approximately 12” from the
bottom due to the safety check valve. If it does, slowly
raise the body a few inches and SLOWLY lower the
body down. The body needs to be lowered extremely
slow the last 12 inches or the check valve will stop the
body.
5. Once the body is completely down close the latch hooks
so that the red indicator light comes on.