10
Threading the machine
Single needle
Raise take-up lever to its highest position by turning hand wheel
toward you. Raise presser foot.
Place spool of thread on spool pin as shown, with thread coming from
the back of the spool.
1. Feed the thread into the top thread guide.
2. Pull the thread down through the tension control and pull it around
the tension control loop and upwards.
3. Slide the thread into the thread take-up lever from the right to the
left.
4. Pull the thread downwards and pass it behind the lower thread
guide.
5. Continue to pull the thread down and slide it into the needle bar
thread guide.
6. Thread the needle, from the front to the back.
NOTE: Cut the thread end with sharp scissors for easier needle
threading.
Twin needle
How to thread the twin needle:
1. Thread the left needle according to the way of threading single
needle from step one to step four, then fix the thread into the twin
needle spring as point 5 in the right picture. Draw thread down and
slip it into needle bar thread guide 6. Finally thread into the left
needle eye from front to back.
2. Thread the right needle according to the way of threading single
needle from step one to step seven.
2
3
5
7
2
3
5
7
2
7
.
8
Left needle thread
Right needle thread
CAUTION
Be sure to thread the left needle thread firstly then thread the right needle thread. Put the thread
spool on the spool pin, make sure that the left thread will run anti-clockwise, the right thread will
run clockwise.
Using automatic needle threader
Raise the needle to its highest position by rotating
the hand wheel towards you.
1. Hook thread to thread guide as illustrated.
2. Pull down lever while holding the end of thread.
3. Rotate the lever to the rear of the machine.
4. Guide thread into hooked end and pull the
thread upward.
5. Return the lever and needle will be threaded
automatically.
6. Release the lever and pull thread away from you.