6
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER
1. Remove the exterior and interior packaging. Check that ice basket and ice scoop is
included. If any parts are missing, please contact our customer service.
2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket and
clean it
3. Find a location for your ice maker that is protected from direct sunlight and other
sources of heat (i.e.: stove, furnace, radiator). Place the ice maker on a level surface.
Maker sure that there is at least 6 inches of space between the back and sides of
your ice maker and the wall.
4. Allow one hour for the refrigerant fluid to settle before plugging ice maker in.
5. The appliance must be positioned so that the plug is accessible.
CONNECTING YOUR ICE MAKER
DANGER
* Improper use of the grounded plug can result in the risk of electrical shock. If
the power cord is damaged please call our customer service.
1. This unit should be properly grounded for your safety. The power cord of this
appliance is equipped with a three-prong plug which mates with standard three
prong wall outlets to minimize the possibility of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do
not under any circumstances, cut or remove the third (ground) prong from the
power cord. Any questions concerning power and/or grounding should be directed
toward a certified electrician.
3. This appliance requires a standard 220-240volt, 50Hz electrical outlet with good
ground.
Before using your ice maker, it is strongly recommended to clean it thoroughly.
CLEANING AND MAINTAINING YOUR ICE MAKER
1. Take out the ice basket.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. Then use the water to rinse the inside parts, and drain out the water from the
draining port by unplugging the drain cap on the back.
4. The outside of the ice maker should be cleaned regularly with a mild detergent
solution and warm water.
5. Dry the interior and exterior with a soft cloth.
