mega macs PC
4. Select the requested assembly.
5. Select the requested system.
6. Observe the information and instructions windows.
7. Call up the
>Information<
tab.
8. Follow the instructions on the screen.
9. Start the manual basic setting with
.
10. Regard the window with infos and instructions.
11. Follow the instructions on the screen.
12. Confirm the performed basic setting with
.
11.5.6.3 Performing Automatic Basic Settings
WARNING
Wrong or incorrectly performed basic settings
Risk of injury or material damage to vehicles
Regard the following when performing basic settings:
•
Select the correct vehicle type.
•
Regard the window with infos and instructions.
Proceed as follows to perform the automatic basic setting:
1. Perform steps 1 to 11 as described in the section
CAUTION
Pulling off of the PC VCI when actuating the clutch
Risk of injury or material damage
Proceed as follows before starting:
1. Apply the parking brake.
2. No gear is engaged.
3. Regard the window with infos and instructions.
NOTICE
Short circuit and voltage peaks when connecting the PC VCI
Danger of destruction of automotive electronics
Switch off ignition before connecting the PC VCI to the vehicle.
2. Connect the PC VCI to the vehicle's diagnostic connector.
Both LEDs of the PC VCI flash. The PC VCI is ready for operation.
3. Select
Diagnostics > Function > Basic settings
.
NOTE
The selection of the following possibilities depends on the selected manufacturer and vehicle
type:
•
Functions
•
Assemblies
•
Systems
•
Data
72