Tess 308 Installation Manual – Issue 1 (DR1004, July 2014) Page | 14
8. Radio Motor Limits Setting
8.1
Important
Only power up one motor at a time.
Have the transmitter within 3m of the motor during setting process.
Motors acknowledge by running briefly in both directions (shuffle).
Motor will only run in deadman (impulse) mode until a transmitter is added to the
memory.
Setting motor limits
1.
Connect the mains supply to the motor. This should be via an isolator switch in case
programming has to be wiped.
2.
Press the up and down button at the same time to initiate programming, the motor will
acknowledge. The motor operation will be impulse only at this stage.
Checking the motor direction
1.
Press the up button on the transmitter. The blind should retract. If the motor direction is
incorrect then press the middle stop button for approximately 3 seconds. The motor will
acknowledge.
Setting the end limits
1.
Press and hold the down button and the motor will deploy. Continue this until the required
deployed position is reached, use the up/down buttons to achieve the correct position. To
memorise the fully deployed position press the stop and up button simultaneously. The
motor will then run automatically in the retract direction.
2.
When the motor arrives at the desired retract position press the stop button. Should it be
necessary to adjust the final position use the up/down buttons.
3.
To memorise the limit position press the stop and down buttons simultaneously. The
motor will now run in the deploy direction automatically. To validate the settings press
and hold the stop button for 2 seconds. The motor will acknowledge.
Confirming the master transmitter
1.
To operate the motor in stable mode press the programming button for approximately 1
second, the motor will again acknowledge . This is now the master transmitter and can be
used to programme additional transmitters.
