Guralp Systems CMG-DM16R8, Руководство по эксплуатации

Страница: 32 / 44

CMG-DM16
0 38400 BAUD
1 4800 BAUD
This will reset a standard DM16 to its default configuration.
The allowable values for
baud-rate
are 4800, 7200, 9600,
14400, 19200, 38400, 57600 and 115200. For compatibility
reasons, 1152 is also accepted, setting the baud rate to
115200.
GPS inputs should always be set to 4800 baud.
RE-BOOT
Syntax:
RE-BOOT
(interactive)
Causes the DM24 to reset after a delay of 2 s.
RE-BOOT
Confirm with 'y' ? y
Responding to the confirmation message with anything other
than
y
will abort the reset.
5.5 Output configuration
SAMPLES/SEC
Syntax:
tap-0 tap-1 tap-2 tap-3 samples/sec
The DSP software on the DM16 supports up to 7 cascaded
filter/decimation stages. At each stage, the sample rate can be
decimated by a factor of 2, 4 or 5. The ADC within the unit
outputs data at 2000 samples/sec, so decimated data streams
are available from 1,000, 500 and 400 samples/sec down to 1
sample/sec.
You can specify the sample rate to use at four of these stages,
known as
taps
. You can also take output from any of these four
stages. The DM16 will arrange the remaining stages according
to your settings.
The arguments
tap-0
to
tap-3
are the sample rates at each
tap in turn, starting with the highest. You must ensure that each
rate is lower than the previous one by a factor of 2, 4, 5, 8 (= 2
then 4), 10 (= 2 then 5) or 16 (= 4 then 4). Non-integer values
are not allowed.
32 Issue C