Gunnebo GlasStile GSS, Инструкция по установке, эксплуатации и обслуживанию

Страница: 28 / 34

28
.............................
CCEC/ OM Manual GlasStile GSS 1.6 EN 07 .2009
Scratches on Brush (Satin) Finish
Cleaning agent:
For slight scratches, use impregnated nylon pads then polish with scruffs
dressed with iron free abrasives. For deeper scratches, apply in direction of
polishing. Then clean with soap or detergent as per routine cleaning.
Action:
Do not use ordinary steel wool, iron particles can become embedded in
stainless steel and cause further surface problems.
Greasing
Service Engineer carries out this action during service visits.

General Indications
The mechanism should be inspected and cleaned at regular intervals in order to maintain the
components in good working order and to check for signs of wear.
Note : The following indications refer to an installation where the average number of transits per year
is equal to one million.
When used in dusty conditions, increase the inspection intervals.
Warning - To avoid the risk of electric shock, always ensure that the electrical power is disconnected
before inspecting the mechanism.

Lubricants
For the lubrication of parts subject to wear, use Molycote BR2 Plus grease or equivalent grease
containing graphite or molybdenum sulphide (MoS)
Do not grease moving parts unless specifically indicated in this manual. The use of grease can lead to
a build up of dust that can impair operation of the mechanism.
Components
Annual Checks (Operations to be carried out with the power supply disconnected)
Cables and Connectors (Operations to be carried out with the power supply disconnected)

Check that the wire connectors are firmly attached.

Check that the terminals are fully tightened.

Check that the insulation of the wires is in good condition and that no conductors are exposed.
Electrical Circuits
No general maintenance is required apart from replacement fuses in the event of a failure.
General Component Maintenance
Ensure the assembly is kept clean.