1.
To fill water:
The foot-spa is provided with a single hot and cold mixing valve located on the front of your spa.
This is a pressure balance valve that requires you to lift the handle to start the water flow and to adjust to the
temperature that is desired. The jet motor must be completely submerged in water.
CAUTION: DO NOT USE FOAMING, SUDSING OR MINERAL OIL BASED ADDITIVES IN THE WATER.
2.
To start whirlpool:
Press the button as shown. This will start your Jet motor. You may stop the whirlpool function at any time by pressing
the button again.
3. The foot-spa is equipped with a hand held sprayer. To activate the hand shower, pull the hand shower
from the receptacle and depress the thumb control on the sprayer handle. This will turn on the water. When you
release pressure on the thumb control this will turn the water off.
4.
To drain whirlpool tub:
The spa is equipped with a built in optional discharge pump. Open the drain plug by turning the control knob as shown
above. Press discharge pump timer button (Pump will run for approx. 2 min.) Average time for drain 1 minute.
Control Panel Glass Bowl Model
OPERATIONS & USE
11
BASIC PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING:
1. Read and follow all instructions
2
. DANGER
. To reduce the risk of injury, do not permit children to use this unit unless they are supervised at all
times
3. Use this unit only for its intended use as described in this manual. Do not use attachments that are not
recommended by the manufacturer.
4. Never drop or insert any object into any opening.
5. Do not block jets during whirlpool operation.
6. The unit must be connected to an electrical supply circuit that is protected by a ground fault circuit interrupter.
7. The clean jet motor is magnetically driven and is insulated twice. Therefore it does not require to be bonded.
Save these instructions
13
Jet (On/Off)
Water Control
Drain Control
Hand Spray
Model # ST700.20
Jet (On/Off)
Water Control
Drain Control
Hand Spray
Model # ST700.20
Control Panel Acrylic Tub Model
