23
DH200 Manual
Rev 16.0
To change the default style (the style that comes whenever you power up the Digital Hymnal),
just select the desired style (STYLE, 642,
, then press the STYLE button, 1000 on the
keypad, then ENTER
. The LCD display on the Hymnal will confirm your selection. The
selected style will be the new default style after turning the Digital Hymnal off and on.
SOLO
Allows the values associated with the four parts to be modified. SOLO
is used to select one of the parts — SOPRANO, ALTO, TENOR, or
BASS — to either isolate a part or to bring in parts one at a time.
Orchestration
Buttons
The sounds available in the Hymnal are listed in the General MIDI
Sound List section of this manual. These sounds can be assigned to any
of the four parts in any hymn, allowing the user the freedom to create
new orchestrations. To assign a sound to a part, select the part by
pushing one of the part buttons — SOPRANO, ALTO, TENOR, or
BASS, push any one of the sound buttons located in the BLUE area of
the remote. You may also pick a sound from the General MIDI Sound
List and enter its number. For example, to assign Pipe Organ 2 (sound
# 97) to the Alto part, press ALTO, then press any sound button,
,
,
and
(Enter).
MELODY/SOPRANO
ACC. 1/ALTO
ACC. 2/TENOR
CONTRA/BASS
Change the volume of
a part
Change the relative volume of the melody by pushing MELODY and
then using the VOLUME
&
buttons to change the melody's
relative loudness in the "mix" among the four parts. (If more than five
seconds elapse between pushing MELODY and using the volume
controls, the Hymnal will cancel the MELODY command and apply
the volume changes to the master volume.)
Using the Performance Style Presets
The four Style Preset Buttons (
see the Remote Control illustration at the beginning of this
manual
) allow quick access to some of the most commonly used performance styles. Each of
these buttons toggle between the two styles shown above and below the button. For example,
pressing the button marked “Carillon” will automatically select a Carillon style without making
the user go through the process of entering the appropriate code. Pressing this same button again
will then switch to the Orchestra style.
As the style is selected, the corresponding preset code for that style is displayed on the screen.
These are the same preset codes which we discussed in the last section. If you are interested in
finding out which style is being used by the Preset Buttons, you can simply look up the code
which appears on your screen in the tables on the previous pages.
Changing the Default Style:
Содержание DH-200
Страница 38: ...38 DH200 Manual Rev 16 0 February 25 2007 ...
Страница 39: ...39 DH200 Manual Rev 16 0 ...
