11
DH200 Manual
Rev 16.0
6
Advanced Functions
SOLO PARTS
- Parts can be "soloed" or isolated and modified individually. First, choose a
simple single-digit style such as
STYLE
2. Isolate the soprano part by pushing
SOPRANO
,
followed by
SOLO
. Bring back the other three parts by pushing
SOLO
again. The other
parts can also be added one by one after a part has been soloed. Add the Alto part to the
previously soloed soprano by pressing the
ALTO
button.
TEST THE METRONOME
-
Try the metronome by pushing the
METRONOME
button
located in the lower part of the remote. Turn the metronome off by pushing its button again.
BALANCE PARTS
- Sounds and their relative volume levels can be changed. Set Hymn
305 to
STYLE
2. Select the soprano part with the SOPRANO button, choose the BRASS
sound, and then use the
VOLUME
controls to adjust the soprano's relative volume to about
95. Next, use
ALTO
,
CLARINET
, and
VOLUME
controls to have the alto play a clarinet at a
volume of 90. Using the same method, assign
STRINGS
to the
TENOR
part at a volume of
80 and assign
PIPE ORG
to the
BASS
at a volume of 99.
You must adjust the volume fairly quickly after pressing the button of the part you want to
adjust,
SOPRANO
,
ALTO
,
TENOR
, or
BASS
. Otherwise you will be adjusting the master
volume of the entire Hymnal, not just the individual part. You can see on the display which
volume is being affected.
Changing the way a hymn is performed.
1. Choose the number of verses you want the Hymnal to play.
The factory settings for the number of times that a verse is repeated is taken from the
hymnbook and can be changed using the
VERSES
function. Turn the Hymnal on, select
hymn 305, from
Master Index,
and tell the Hymnal to play two verses by pushing
VERSES
, 2, and
(Enter). Play the hymn.
2. Choose whether or not to play an Amen
.
The Hymnal will only play an Amen when it is asked to, and only on the currently selected
hymn. When the
AMEN
button is pushed, the top of the display should read
Play Amen
.
To disable the Amen function, push the
AMEN
button again.
No Amen
should appear in
the display.
Begin the hymn with an introduction
.
Pushing the STOP/INTRO button after the hymn number has been selected will prompt
the Hymnal to play a short introduction. Immediately following the introduction, the hymn
itself will begin to play. Use this button instead of PLAY if you want an introduction.
3.
Содержание DH-200
Страница 38: ...38 DH200 Manual Rev 16 0 February 25 2007 ...
Страница 39: ...39 DH200 Manual Rev 16 0 ...
