Page 8
Final Setup Steps
1. CONNECT THE BUTTKICKER MINI CONCERT TO THE BKA-130-C POWER
AMPLIFIER
1. Connect the 10’ speaker wire to the bare speaker wire ends of the ButtKicker
mini Concert. (See Fig. 5). Wire nuts (not included) will assist in making this
connection.
2. You can use the included cable ties to strap the speaker wire down to part of
the frame of your sim rig/cockpit.
3. Connect the other end of the 10’ speaker wire to the 5-way binding post
outputs on the back of the amplifier (“Class 2 Wiring, Speaker Level Output”).
Note: To keep strain from pulling the wires out of the wire nuts, cable tie each set of wires together
about 1 inch away from the wire nuts.
2. RUBBER ISOLATORS
The included RI-4 rubber isolators help ‘float’ your rig/cockpit off the floor, dramatically
increasing the efficiency and perceived strength of the ButtKicker system.
1. Set as many rubber isolators as needed under the frame of your sim rig/
cockpit.
Fig.5
