REV.0 CODE G503155E PAGE 5
4.4 ACTIVATION OF THE ADAPTOR RELAY WHEN THE STREET PANEL CAMERA IS ACTIVATED
This configuration is used, for example, to light the area covered by the camera with an auxiliary lights while the
camera is active. The switches are set as follows:
SWITCH A:
configured with the
street panel number
(in the diagram, street panel
number 1).
SWITCH B:
must be
switches 2, 3 and 4
must be in the ON position. The rest must
remain OFF.
SWITCH C:
switches 3, 5 and 8
must be in the ON position and the rest set to the
OFF position. The positions of switches 6, 7 and 8 define the end of the relay
activation (see section 5), in this case when the camera is switched off (end of
communication).
The connections diagram for this operating mode is shown in
FIGURE 1
(page 5).
FIGURE 1: Connections schematic for the operating modes explained in sections 4.1, 4.2, 4.3 and
4.4.
R3660
BUS
2M
COM
NC
NO
3M
1M
2M 3M
1M
220Vac
1M 2M 3M
3M
1M
2M
3M
1M
2M
DIGITAL BUS
MONITOR OR
TELEPHONE
RELAY
CONTACTS
Auxiliary light,
siren, etc.
(Configure switches according to operation mode)
DIGITAL BUS
STREET PANEL
3
SWITCH A
1
2
7
8
6
4
5
1
2
SWITCH B
3
5
6
8
7
1
2
SWITCH C
3
4
5
6
8
7
4
