Customer Helpline 0333 3201989
20
Assembly Instructions
12�3� Angular cuts (See Fig� O)
To enable you to perform angular cuts parallel to the blade (26), the table (15) can be tilted
forwards between 0
o
-45
o
.
Undo the Fixing Handles (18).
Tilt the Saw Table (15) forwards until the required angle value is set on the Dial Scale (16).
Re-tighten the Fixing Handles (18).
Important: When the table (15) is tilted, place the parallel guide (24) to the right of the
blade (26) looking in the direction hi which you are working, on the side pointing downwards
(provided the workpiece is wide enough) in order to stop the workpiece from slipping off.
Before putting the tool into operation
Make sure the tool stands securely, i.e. bolt it to a workbench or solid base. There are four
holes for this purpose in the tool foot.
The saw table must be mounted correctly.
All covers and safety devices have to be properly fitted before the tool is switched on.
It must be possible for the blade to run freely.
When working with wood that has been processed before, watch out for foreign bodies such
as nails or screws etc.
Before you actuate the On/off switch, make sure that the saw blade is correctly fitted and
that the tool’s moving parts run smoothly.
Before you connect the tool to the power supply, make sure the data on the rating plate is
the same as that for your tool.
Caution! After every new adjustment we recommend you to make a trial cut iin order to
check the new settings.
For all cutting operations It is important to position the Blade Guide (11) as close as
possible to the workpiece.
C
A3
A4
A5
F3
B1
B2
G
J
K
N1
N2
O
P
Q
D3
D1
D2
L
M
A1
A2
I1
I2
H1
H2
F1
F2
E
18
27
2
1
30
32
33
31
28
34
28
29
29
35
11
36
37
17
b
a
24
21
15
26
24
15
c
d
Operating Instructions
