GUIDO RAYOS X NESTORET 5050, Руководство пользователя

Страница: 23 / 60

GUIDO RAYOS X, S.A.
NESTORET 5050
23
MAN-011
Feb. 01
Ed. 2 / Rev. 1
can be silenced. This alarm do not interfere on the operation of the
Incubator. If the alarm conditions remain during a period of ten minutes,
the alarm will be activated again.
To switch off the alarm operation, if desired, refer to chapter II.6.
" SENSORS ACTIVATION AND DEACTIVATION ".
If any alarm has been silenced the display will work intermitently, in
order to see better the situation of the silenced alarm.
II.6. SENSORS ACTIVATION AND DEACTIVATION
The applications program of the NESTORET 5050 Incubator allows to the user, at any
moment, to deactivate or activate the sensors of the monitored parameters, if required
for calibration procedures or non essential parameters cancellation (Oxygen and/or
Relative Humidity). If the Incubator is switched off, proceed as follows:
Press I/O switch, located at the side of the trolley. Press ON/OFF key at the front
panel. The LCD will display ,
GUIDO RAYOS X
VER X.X
then type sequentially:
•
SILENCE key
•
7388
•
SILENCE key.
•
ENTER
then the LCD will display ,
MAINT: 0 SW, 1 LNG
2 SEN, 3 DIS, 4 RNG
Press 2 key and the LCD will display all coded available sensors and their status as
follows,
1RH 2AT 3ST 4HT
5FA 6OX 7A2 8AI
(at the right side of each coded sensor " + " or " - " will display, meaning activated or
deactivated respectively)
(RH=Relative Humidity, AT=Air Temperature, ST=Skin Temperature, HT=Heating
Device Temperature, FA=Fan, OX=Oxygen, A2 and A1 are auxiliary options for future
implements)
To activate (+) or deactivate (-) press the corresponding figure key of the sensor.
Proceed with any sensor you want to activate or deactivate, then press ENTER to
confirm.