Lengthwise Cutting
Fig. 7
•
Set the parallel stop (Fig. 1/pos. 8) at the
required width in relation to the saw disc.
.
•
Lay the work on the bearing surface are,
the flatter/wider side should lay flat on
the saw bench.
•
Guide the wider work with hand, the
smaller one with use of a sliding guide
rod (Fig. 2/pos. 14).
Caution:
Keep a large safety distance
from the saw disc.
Cross Cutting
Fig. 8
•
Now, the cross stop (Fig. 1/pos. 7) is to
be put on the parallel stop (Fig. 1/pos.
8).
•
In addition, if you want to set the disc
inclined in addition, proceed according
to Fig. 5.
Caution:
Hold the worked piece
tightly, never cut a piece held loosely.
Saw Dust Exhaust
Fig. 9
•
If the unit is used in closed rooms, it has
to be connected to a suitable dust
exhaust.
Operator Safety Instructions
•
Before switching the unit on, all the safety and protection devices have to be fitted at correct places. .
•
Never cut pieces of wood so small that they cannot be held safely.
•
The saw disc has to turn freely.
•
If working wood treated or processed in any way before, special attention should be paid to nails, screws etc. Before getting
down to work, remove any foreign objects.
•
Before switching the main switch on, make sure the saw disc is fitted correctly and all the unit moving parts are free.
•
Warning! If in doubt at the assembly of this circular bench saw, consult an expert at an authorised servicing centre.
•
Do not use the unit before you have read the operating manual carefully.
•
Observe all the safety instructions indicated in the manual.
•
Be responsible to the others.
20
