Gude Expert Power Control NET 8x 8210, Руководство пользователя

Страница: 5 / 26

5
Expert Power Control NET 8x 8210 / 8211 Security Advise
1 Security Advise
The device must be installed only by qualified personnel according to the following installation and operating instructions.
The manufacturer does not accept responsibility in case of improper use of the device and particularly any use of equipment
that may cause personal injury or material damage.
The device contains no user-maintenable parts. All maintenance has to be performed by factorytrained service personnel.
Check if the power cord, the plug and the socket are in proper condition.
The device can be connected only to 230V AC (50 or 60 Hz) sockets.
Always connect the device to properly grounded power sockets.
The device is intended for indoor use only. Do NOT install them in an area where excessive moisture or heat is present.
Because of safety and approval issues it is not allowed to modify the device without our permission.
Please note the safety advises and manuals of connected devices, too.
The device is NOT a toy. It has to be used or stored out or range of children.
Packaging material is NOT a toy. Plastics has to be stored out of range of children. Please recycle the packaging materials.
In case of further questions, about installation, operation or usage of the device, which are not clear after reading the manual,
please do not hesitate to ask our support team.
2 Description
The Remote Power Switch Expert Power Control NET 8x 8210 / 8211 allows the switching of electrical devices via a TCP/IP
network and a serial interface.
For installation just connect the power and network cables to Expert Power Control NET 8x 8210 / 8211.
After the device has received an IP address every client in the same network is able to switch the eight Power Ports (max. 10
A) via webinterface. Expert Power Control NET 8x 8210 / 8211 offers also features like SNMP and Syslog. Additional
Expert Power Control NET 8x 8210 / 8211 can be controlled via a serial connection.
A temperature sensor and a hybrid sensor (temperature and humidity) can be connected to Expert Power Control NET 8x
8210 / 8211.
A watchdog function for each power port is implemented.
The display on the front is able to show the IP address, the recent total load, the peak current (timeframe adjustable) and the
measurements of the sensors.
Furthermore the access to the device can be restricted by IP access control lists and a HTTP password.