Gude Expert Power Control NET 8x 8210, Руководство пользователя

Страница: 11 / 26

11
Expert Power Control NET 8x 8210 / 8211 Configuration
4.3.1.2 After power-up switch
The Power Port’s switching state after a power-on of the device can be defined here (on, off, remember last state).
4.3.1.3 If switching on after power-up, wait ...
A switching delay of a Power Port can be defined here that is applied after switch on of the device. The delay can last up to
8191 seconds.
4.3.1.4 After turning off, wait ...
While this function is enabled, the Power Port will reactive after the stated time, when it got switched off.
4.3.1.5 Watchdog
While using the watchdog, electrical devices can be observed. The watchdog sends ICMP-pings or TCP-pings to the device. If
these pings were not answered, during a defined delay (time or pings), the power port will reset. The watchdog function allows
to restart e.g. crashed servers or NAS systems.
You can check the watchdog function and other imformation inside of the switching menu. There are different colors:
Green text: Watchdog is active and receives ping replies
Orange text: Watchdog is activating at the moment, waiting for first ping reply
Red text: Watchdog is active and does not receive ping replies any longer
When watchdog is activating it waits of a first ping reply. During this time, the information is written as an orange text. After the
receive of the first ping reply, it switches to active, written in green letters.
When a watchdog reset a power port, the watchdog again waits for a first ping reply, as stated above.
4.3.1.5.1
Enable Watchdog
Here you can activate the watchdog for this power port.
4.3.1.5.2
Watchdog type
Here you can switch between ICMP ping or TCP ping.
4.3.1.5.3
Host IP
Here you can enter the IP address this watchdog should observe.
4.3.1.5.4
TCP Port
If TCP pings are used, here you can enter the TCP port. A TCP port is not needed, when ICMP pings are choosen.
4.3.1.5.5
Ping interval
Here you can enter the time between two pings.
4.3.1.5.6
Ping retry
Here you can enter how often the ping should be repeated, before a power port reset will be done.