Gude 86009 GHD 100, Перевод оригинальной инструкции по эксплуатации

Страница: 13 / 14

Filter Cleaning/Checks – Vario Nozzle Cleaning
Unscrew the adapter on the water supply connection and
pull out the filter sieve by narrow, flat pliers. Rinse the filter
sieve with water and insert it back in. A damaged sieve
needs to be replaced.
ATTENTION! Under no circumstances put the high-
pressure cleaner into operation if the filter sieve is
damaged or missing.
Use a thin wire to clean the Vario nozzle or to remove
potential obstructions. See below.
Defect Detection
The following table shows possible defects, their potential
causes and means of their remedies. If you are unable to
solve the problem nonetheless, approach a qualified
specialist.
Prior to maintenance and cleaning, turn the device
off and unplug it.
Danger of electric shock.
Symptom Possible cause Remedy
The device is not
plugged into the
grid Plug the device
into the grid
The socket is
defective Use another
socket
The fuse has
blown Replace the fuse
The engine
doesn’t start
The extension
cord is damaged Try to use the
device without the
extension cord
The fuse has
blown Replace the fuse The engine
stops
The network
voltage is not right Check the network
voltage, it has to
correspond to the
type label
specifications
The fuse has
blown Too weak a fuse Connect to an
electric circuit
which is properly
protected with
respect to the
high-pressure
cleaner
performance
Excessive
effective
pressure The nozzle is
partly clogged Clean the nozzle
There’s air in the
water hose or in
the pump Turn the high-
pressure cleaner
off and let it run
with an open spray
gun and open
water faucet long
enough to reach
an even effective
pressure Pulsing
pressure
The water supply
is incorrect Check whether the
water supply
connection
corresponds to the
technical
specifications. The
smallest water
hose allowed has
the diameter of ½“
or
Ø 13mm
Clogged water
filter Clean the water
filter
The water hose is
clamped or
broken Straighten the
water hose
Worn-out nozzle Replace the
nozzle The pressure
is stable yet
too low
Worn-out
Start/Stop valve Pull the trigger 5
times in a quick
succession
The water supply
is not connected Connect to the
water supply The engine is
running, yet
there is no
effective
pressure
The filter is
clogged Clean the filter
The high-
pressure
cleaner turns
on
spontaneously The pump or the
spray gun leaks Turn to an
authorized
specialist
The device is
not pressure-
tight The pump is not
pressure-tight 6 drops per minute
are acceptable. In
cases of abnormal
leakage, it is
necessary to
consult the
problem with a
specialist
21