Gude 86009 GHD 100, Перевод оригинальной инструкции по эксплуатации

Страница: 10 / 14

Use protective goggles
Attention! Observe
unconditionally the order
of connection and never
use the device without the
water inlet connected –
danger of damage!
Environmental protection:
Dispose of waste in a
qualified fashion so that you
do not harm the environment.
The packaging material
made of cardboard can be
submitted for recycling to a
recycling plant.
Defective and/or liquidated
electric and electronic
devices must be submitted to
the respective disposal
plants.
Package:
Protect from dampness.
The package must point
upward.
Interseroh-Recycling
Technical specifications:
Connector Weight
IPX5
Engine performance Protection type
Maximum pressure
Maximum temperature of
the inlet water
Flow volume in liters
Purpose-Consistent Usage
Use this high-pressure cleaner exclusively for private
purposes:
• To clean machines, vehicles, buildings,
instruments, façades, terraces, garden
machines, etc., by a spray of high-pressure
water (in case of need, the product #86009
provides cleaning with a detergent admixture).
•
With accessories and spare parts approved by
the company Güde GmbH & Co. KG. (adhere to
the usage instructions which are appended to
detergents).
Any other type of usage constitutes an act of purpose
violation. The producer cannot be held accountable for any
subsequent damage or injury resulting from inappropriate
use. Please take heed to the fact that our devices
are not
constructed for commercial purposes (industry, craft,
business).
Assembly
Attention! Prior to maintenance, cleaning and assembly, it
is necessary to switch the device off and unplug it. The
same has to be done in the event that the feed cable is
damaged, incised or tangled.
Observe the system voltage: the power supply voltage
must correspond to the specifications on the type label of
the device.
The extension cord with a small conductor cross section
significantly reduces the performance of the device.
Cables up to 25 meters of length should have at least 3 x
1.5mm²; longer cables should have at least 2,5mm².
Attention! Unapproved extension cables must not be used.
The extension cord, the plug and the joint must be water-
proof and approved for outdoor usage.
Cable joints must be dry and must not lie on the ground.
If a cable drum is used, it is necessary to reel it off.
Water Connection (picture A5) (picture C7)
• Adhere to your local waterworks’ directives.
• Screw joints on all connecting hoses must be
tight.
•
Damaged high-pressure hoses must not be
used (danger of rupture).
The following accessories are necessary to connect the
high-pressure cleaner to water supply and are not part of
the delivery:
•
A textile hose with the minimum diameter of
13mm;
• A commonly marketed hose connector.
Connect the textile hose to the connecting component of
the high-pressure cleaner and screw this on the high-
pressure cleaner itself.
Now connect the second piece of the hose to the common
hose connector and subsequently to the water supply.
Caution! According to the effective regulations,
the device must not ever be used without a system
disconnector in the drinking water network. It is necessary
to install an appropriate system disconnector in
accordance with EN 12729 type BA. Water which runs
through the system disconnector is no longer drinkable.
Assembly of high-pressure cleaner GHD 100 #86009
Assemble the spray lancet and the spray gun. Proceed in
the following fashion:
Screw part 1 of the spray lancet
(picture B15/8) onto the
spray gun (picture B15/9) (picture A6+A7) .
18