GÜDE Expert Net Control 2304, Руководство пользователя

Страница: 20 / 93

20
Expert Net Control 2304 © 2022 GUDE Systems GmbH
Operating
The command "system fabsettings" from the beginning of a generated configuration file
brings the device into the factory state, and then executes the individual commands that
modify the configuration state. It may be desirable to make the changes relative to the
current configuration, and not out of the factory state. Then the "system fabsettings"
should be removed.
No output of default values
The configuration file contains (with exceptions) only values which differ from the default.
The command "system fabsettings" (go to the factory state) from the beginning of a gen-
erated configuration file should not be removed, otherwise the device can get incom-
pletely configured.
Configuration via Telnet
The configuration files can in principle also be transferred in a Telnet session, but then
the settings are changed during operation, and not completely when restarting, as it
would have been the case with an upload. It can happen that events are triggered at the
same time as the device is configured. One should therefore:
a) disable the function
b) completely parametrize
c) reactivate the function
An example:
email enabled set 0
email sender set "" #len: 0..100
email recipient set "" #len: 0..100
email server set "" #len: 0..100
email port set 25
email security set 0 #range: 0..2
email auth set 0 #range: 0..2
email user set "" #len: 0..100
email passwd hash set "" #len: 0..100
email enabled set 1 #range: 0..1
2.3.3
Bootloader Activation
The configuration of the device from the application "GBL_Conf.exe" is only possible, if
the device is in Bootloader Mode.
Activation of the Bootloader Mode
1) via push button:
·
Hold both buttons for 3 seconds
2) or
·
Remove the power supply
·
Hold down the "Select" button. If the push button is recessed, use a pin or paper clip