27
EN
Important information for the
customer
Please note that returns within or outside the warran-
ty period should always be in the original packaging.
This measure effectively avoids unnecessary transport
damage and any associated disputed ruling. Your
equipment is optimally protected only in the original
box, and keeping it in that box will ensure smooth
processing.
Failure removal
Issue
Causes
Removal
Electric arc turned off
Poor contact between earth pliers
and the respective part
Tighten the pliers and check them
Remove paint and rust
Short circuit between current nozzle
and gas supply pipe
Clean or replace the current and gas
nozzle
Current nozzle without dirt, paint and
rust remains
Too loose current nozzle
Tighten the current nozzle firmly
Welder suddenly stops working
after longer operation
Welder has overheated due to too
long use and the thermal protection
has activated
Let the welder cool down
Appliance does not ignite
Arc not ignited within 0.3 sec - HRD
lights up red
Release the burner button and ignite
again. -> S.10
Bad cutting result
Burner nozzle / electrode worn out
Replace burner nozzle / electrode
ENGLISH
