Having done this, follow the steps outlined below and illustrated in Figure 7:
Figure 7A. Lock the green pump rod.
Figure 7B. Press the white button until it is in contact with the spring-loaded
safety lock, to release any residual pressure.
Figure 7C. Now open the safety lock and push the white button all the way home.
Note: do not raise the red security lock until after performing the procedure
described in Figure 7A and 7B.
Figure 7
Figure 9
Steps for selecting the SIPHON Function
To start the Siphon function unlock the handle and pump 20 - 30 strokes to create
a vacuum (Figure 8A) and insert the nozzle into the liquid to be drained and
squeeze the trigger to transfer the liquid to the tank (Figure 8B).
To facilitate the operation, the flow control valve has a lock-on function, which
allows you to lock the trigger in the open position; to use it, press the trigger and
push the red lever, as shown in Figure 9B and to disengage the lock, push it back
in the opposite direction.
Figure 8
Use of equipment
'Lock-on'
6.2.1 . SIPHONING OF LUBRICATING OIL FROM VEHICLES
AND ENGINES IN GENERAL
Before siphoning oil from engines read and apply the following guidelines:
!
First, make sure that the vehicle/engine is located on a level surface.
!
Run the engine for a few minutes to warm the oil, making it less viscous; then
turn the engine off and wait two to three minutes before starting the suction
process. Note: For removal of oil from automobiles, see the procedure in the
vehicle's handbook.
!
Remove the engine’s oil level dipstick and use it as a reference to know how deep
to insert the suction tube.
!
Insert the suction tube into the dipstick hole until resistance is encountered.
IMPORTANT
BEFORE SIPHONING LUBEOIL IN ENGINES:
The GUARANY Big Sucker Pump was designed for use with various vehicles and
engines. However, differences in the settings of the oil dipstick level and also the
crankcase configuration format can hamper or prevent the use of this equipment.
Therefore, before using it for the removal of engine oil from your vehicle/engine,
check the manual and/or any authorized dealer to confirm the possibility of oil
extraction by suction.
OPERATOR'S MANUAL |Big Sucker (Siphon & Discharge Pump)
33
6.3 DISCHARGE
Figure 10
Steps for selecting the DISCHARGE function
Always try to clean the equipment (as per item 7.1 of this manual) before starting
any maintenance.
7. CARE AFTER USE
7.1 CLEANING AND STORAGE OF THE EQUIPMENT
8. REGULAR EQUIPMENT MAINTENANCE
!
ATTENTION
!
ATTENTION
WE RECOMMEND THE USE OF PERSONAL PROTECTION FOR BODY, HANDS,
FEET AND EYES DURING THE OPERATION OF THIS EQUIPMENT AND DURING
CLEANING AND CARE AFTER USE
IMPORTANT
Fully drain the tank daily, leaving no residue or leftover chemicals, as
this may cause damage to the equipment`s components.
Use protective gloves during maintenance servicing.
OPERATOR'S MANUAL |Big Sucker (Siphon & Discharge Pump)
34
After completion of the siphoning process, switch to the DISCHARGE function,
following the steps outlined below and illustrated in Figure 10.
Figure 10A. Press the black button all the way home .
Figure 10B. Pump 20-30 times to create positive pressure.
Figure 10C. Place the nozzle in the vessel for receiving the liquid and gently
squeeze the trigger to discharge the liquid quickly and safely.
