Issue 08/2013
Page 78
M
A
PL
A - M
odu
la
r e
ne
rg
y s
up
pl
y s
ys
te
m f
or l
oa
d li
ft
in
g m
ag
ne
ts
Installation and commissioning
Generator installation for iMAPLA 8, 13, 17 and 20
Assembly
Ö
Fig. 29, Assembly of the flange mount for the hydraulic drive
(using iMAPLA 13 as an example), page 78
>
Place the flange
[2]
onto the generator and secure with four screws
[4a]
.
>
Place a toothed washer
[4b]
underneath the screws and secure with
Loctite.
>
Place the collar
[1]
and clamp securely with two screws.
>
Mount the first half of the coupling
[5]
on the shaft at the generator and
prevent it from twisting on the shaft using with a key.
>
Mount the washer
[6]
onto the hydraulic motor
[8]
.
>
Place the second half of the coupling
[5]
to the hydraulic motor.
>
Place the hydraulic motor
[8]
with washer
[6]
and the second half of the
coupling on the generator. Where necessary, turn the coupling slightly to
ensure the gearing locks.
>
Place toothed washers
[7b]
to eight screws
[7a]
and secure disk
[6]
to the
flange
[2]
.
>
Place the collar
[9]
onto the coupling unit and tighten firmly with two
screws.
4a
M12 x 35 DIN 912
4b
Spring lock washer DIN 128 A-12
7a
M8 x 30 DIN 912
7b
Spring lock washer DIN 128 A-8
Fig. 29 Assembly of the flange mount for the hydraulic drive
(using iMAPLA 13 as an example)
