15
Bolts
and
Washers
Reducer
Arm
Key
Closed Gate
Closing
Gate Bracket
Operator Arm
Reducer Arm
(approx)
5°-10° Angle
Clevis Pin
Hairpin Clip
Output Shaft
Fig. 1
Fig. 2
Fig. 5
Fig. 6
Fig. 4
CAUTION:
DO NOT STAND
IN THIS AREA
Fig. 3
1
2
3
4
O
N
OPTIONS
MODE 1
MODE 2
OPEN DIR.
SLV OPN
DUAL MODE
LOW BATT
ON
ON
>>>
SIMUL
SLAVE
SECURE
OFF
OFF
<<<
DELAY
MASTER
SAFE
Connecting the Gate Arm to the Gate
NOTE:
Gate Arm’s length can be adjusted
by rotating the gate arm’s tube before
mounting it to the gate bracket.
(Fig. 5)
1.
install the key
into the
output shaft
.
(Fig. 1)
2.
Fit the end of the
reducer arm
onto the
output shaft
as shown and
tighten the bolts.
(Fig. 2)
3.
Turn the
power on
.
4.
set Dip switch 1
to designate the operator arm as
left or right (Fig. 3)
(right is shown here).
5.
Manually
move gate to the closed position
.
(Fig. 4)
6. unfold the arm
to approximately a
5-10° angle
.
(Fig. 4)
7.
Use
‘close’
button on control board to move operator arm/reducer arm to the gate.
CAUTION:
Be careful
not to stand in the gray area surrounding the operator.
(Fig. 4)
Be prepared to stop (using the
‘stop’
button)
when the gate arm and reducer arm near the desired position.
NOTE:
Use
‘JOG’
buttons to fine tune the position.
8. Mark the position
of the
gate bracket holes
on the gate,
drill holes
and
mount bracket
.
9.
Fit the end of the
operator arm into
the
gate bracket
and attach using
clevis pin
and
hairpin clip.
(Fig. 5)
