GTO 2000XLS Instruction Manual © 02.07.12
17
Adjust the Stall Force Setting
The Stall Force potentiometer controls the the amount of force
the opener will apply against an obstruction before it stops and
reverses direction within two seconds.
IMPORTANT: The Stall Force setting will need to be adjusted
to compensate for the weight and size of your gate. For safety
reasons, use the lowest possible setting to operate the gate.
The Stall Force potentiometer on the control board operates like
a volume control on a radio. Use a small flat blade screwdriver
to turn the arrow in the center of the potentiometer. Adjust the
sensitivity from the MINIMUM position just to the point where the
gate operates smoothly without obstructing from its own weight
or wind conditions.
NOTE: You may need to increase the stall force in cold weather
due to increased resistance from gate hinges.
Set Auto-Close Time
The Auto-Close determines how long the gate will remain open
before it automatically closes. The factory setting is OFF. Use a
small flat blade screwdriver, you can adjust the settings to OFF,
or from 3 to 120 seconds.
NOTE: The Auto-Close timer will only funtion if the gate is in the
fully open position.
VAR5
VAR6
K1
PF1
K2
BATT
+
BATT
–
K3
K4
VAR4
VAR3
VAR2
VAR1
MIN
MAX OFF
JP1
REMOVE JUMPER FOR
PUSH TO OPEN OPTION
120
SEC.
G
TO Inc.
Tallahassee, FL
R4722
STALL FORCE
OPEN < JOG > CLOSE
PWR.
SET
LIMIT
1st OPR.
2nd OPR.
STATUS
AUTO CLOSE
SFTY.
EXIT
CYCLE
EDGE
SENSOR
COMMON
LOCK+
LOCK–
WHT
GRN
RED
BLK
WHT
GRN
SECOND OPR
.
FIRST OPR
.
RED
BLK
14 VAC
OR
SOLAR
ON OFF
MIN
MAX
STALL FORCE
VAR5
VAR6
K1
PF1
K2
BATT
+
BATT
–
K3
K4
VAR4
VAR3
VAR2
VAR1
MIN
MAX OFF
JP1
REMOVE JUMPER FOR
PUSH TO OPEN OPTION
120
SEC.
G
TO Inc.
Tallahassee, FL
R4722
STALL FORCE
OPEN < JOG > CLOSE
PWR.
SET
LIMIT
1st OPR.
2nd OPR.
STATUS
AUTO CLOSE
SFTY.
EXIT
CYCLE
EDGE
SENSOR
COMMON
LOCK+
LOCK–
WHT
GRN
RED
BLK
WHT
GRN
SECOND OPR
.
FIRST OPR
.
RED
BLK
14 VAC
OR
SOLAR
ON OFF
OFF
120
SEC.
AUTO CLOSE
