GTM Professional GTS1300C, Руководство пользователя

Страница: 25 / 52

Procedure
1. Start the machine. Refer to the OEM documentation of the specific engine of your
machine.
5.5 Use the machine
Note:
•
For an overview of the product specifications, refer to section
9.2
.
• You can use the machine with either the low output or the high output. To
change the output, refer to section 5.3 .
1. If necessary, remove sand, dirt and
rocks from the material.
2. Cut side branches off the main
branches.
3. Put the material in the input (A).
The machine automatically pulls the
material into the rotor.
4. Put side branches and material with a
large diameter in the input separately.
5. After you put branches with leaves in
the input, always put a thicker branch
without leaves in the input to prevent
a blockage.
5.6 Stop the machine
1. Put the last material in the input. Refer to section
5.5
.
2. Let the machine operate until the shredderbox and the output are empty.
3. Set the throttle lever in low speed position.
4. Set the ON/OFF switch to the OFF position.
5.7 Transport the machine
1. Take out the drive plates of the
transport vehicle to safely pull the
machine on the transport vehicle.
2. Pull the machine on the transport
vehicle.
3. Make sure that the bumper is placed
against a vertical flat surface.
Caution:
Do not use tie-down
straps on the engine or
output.
A
B A
Instructions for use
D09-CC13S20-11 25