12
GMG-200
310-2310-001 EN20
PREPARING FOR OPERATION
5.3 Changing Slider Plate
1
Turn over the GMG-200 and rest it on the handles.
2
Use an Allen screwdriver (3.0) to release the screws.
3
Detach the slider plate from the floor plate.
4
Place the desired slider plate on the floor plate.
5
Use an Allen key and three screws to secure the slider
plate.
5.4 Cleaning Sliders
TIPS AND RECOMMENDATIONS
Use the sanding block to clean the sliders before every use!
The three slider bases are on the slider plate
on the underside of the device. Each slider base is
equipped with one slider.
1
Turn over the GMG-200 and rest it on the handles.
2
Move the sliding block steadily back and forth over the
sliders (sandpaper type 320).
5.5 Changing Sliders
A sensor in the slider plate determines the material of the
respective slider.
When the slide plate is changed, the device automatically
detects the type of material, displays it and saves the infor-
mation along with the respective measured values.
TIPS AND RECOMMENDATIONS
When changing the sliders, verify that the slider material and slider plate match.
F: ON RK: 0,00
Slider: leather
M: 1 S 3
