The DrawingBoard V
28
Replacing Batteries
Replacing the Cordless Cursor Batteries
The cordless cursor requires two AAA batteries. The average battery life
for the cursor batteries is 2,000 hours.
To replace the batteries:
1
Place the cursor face down
in the palm of your hand.
Use a Phillips screwdriver to
remove the two screws
located on the bottom of the
cursor (see figure). Remove
the cursor base.
2
Remove the old batteries
from the battery casings.
3
Place the new batteries in
the casings, matching the
polarity of each battery with
the markings on the connec-
tor strips (match + to +).
4
Reposition the cursor base.
Replace the screws with the
Phillips screwdriver.
When you replace the cordless cursor batteries, the cursor will
reset to the default frequency. If you changed the frequency of
the cursor before replacing the batteries, you will need to do so
again after replacing the batteries (see the
Reducing Monitor
Interference
section in
Troubleshooting
).
