GT POWER GT7005EFi, Руководство по эксплуатации

Страница: 20 / 28

20. 21. www.gtpower.co.nz
www.gtpower.co.nz
GT7005EFi
Replacing the Battery
Replacement battery should be within the fol-
lowing specifications:
Voltage: ≤ 12V
Capacity: ≤ 9~18AH
Dimensions: ≤ 181 x 76 x 167mm (LxWxH)
When the engine is running, the battery will
charge by the charging system on the gener-
ator. If the battery has been stored for a long
period, it will need to be charged prior to use.
If using an alternative charging system, the
charging current should be less than 0.15c
Amperes (c: battery rated capacity).
Rubber Tape
Battery
1. Unhook the rubber tape.
2. Remove the black cable from the battery
negative (-) terminal, and then remove the
red cable from the battery positive (+) ter-
minal.
3. Remove the battery from the battery tray
and replace with a new one.
4. Reconnect red cable to battery positive (+)
terminal, and reconnect black cable to bat-
tery negative (-) terminal.
5. Hook the rubber tape.
Replacing the Fuse
If the engine can’t be started due to low
speed of the starter motor, check charging
fuse or battery voltage. If starter motor does
not actuate during electric starting, check the
starting fuse:
1. Remove fuse holder located near battery.
2. Hold and twist the two ends of the fuse
holder.
3. If the fuse has blown, replace it.
4. Replace the fuse into the holder.
Fuse Specifications
Starting fuse: 4A, 250V/120V
Charging fuse: 2A, 250V/125V
Cleaning the Fuel Tank Filter
1. Remove the fuel cap and filter.
2. Clean the filter with solvent.
3. Wipe the filter and insert it.